Fisher-Price H7185 Swing Sets User Manual


 
Lower Leg
• Position a lower leg so that it stands on a flat surface, as shown.
• Fit a foot onto the end of the lower leg.
• Insert a #8 x 1,3 cm screw through the bottom of the foot
and into the lower leg. Fully tighten the screw with the
Allen wrench.
• Repeat this procedure to assemble the other foot to the
other lower leg.
Foot
• Position an upper leg so that the red dot is up.
• While pressing the button on the straight end of an upper leg,
insert the upper leg into a lower leg. Make sure the button on
the upper leg “snaps” into the hole in the lower leg.
• Repeat this procedure to assemble the other upper leg to the
other lower leg.
Red Dot Up
Lower Leg
Upper Leg
Straight
End
Button
Hole
Assembly
IMPORTANT! Before assembly, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel
for replacement parts and instructions if needed. Never
substitute parts.
Button
Holes Up
Upper Legs
• Position the fabric panel with the button holes up.
• Position the legs so that the feet are away from you.
• Slide the fabric panel onto the upper legs.
Button Hole
Rivet Through
Button Hole
• Fit the rivets on the upper legs through the button holes
in top ends of the fabric panel.
1
2
3
4
4