Filter
Top Products
20
Figure 17. Radiator & Oil Cooler
A. Radiator Pressure Cap
B. Radiator Screen
C. Screen Keeper Handle (LH side hidden)
D. Hydraulic Oil Cooler
E. Wing Bolt
CHECK ENGINE COOLANT LEVEL
The engine coolant level and quality should be checked
before each use, when the engine is cool and off.
1. Remove the radiator pressure cap (A, Figure 17) to
check the fluid level.
2. Coolant level should be 1/2” (13mm) below the bot-
tom of the filler tube. If coolant level is low, add
coolant until level is 1/2” (13mm) below the bottom of
the filler tube. Proper coolant mix is a 50/50 mixture
of ethylene glycol and distilled water. See engine
owners manual for engine coolant specifications.
3. Check the coolant level in the radiator overflow bottle
(Figure 18). If coolant level is low, add coolant until
level is at the “FULL” line. Proper coolant mix is a
50/50 mixture of ethylene glycol and distilled water.
See engine owners manual for engine coolant speci-
fications.
CHANGE ENGINE COOLANT
See engine owners manual for specific engine coolant
procedures. The drain valve is located at the base of the
right-hand side of the radiator.
CLEAN RADIATOR, SCREEN & OIL
COOLER
Clean the radiator, screen and oil cooler fins before each
use, or as required (depending on conditions) to allow
proper air-flow through radiator and hydraulic oil cooler.
1. Raise the seat plate.
2. Remove the wing bolt (E) from the oil cooler mount
and pivot the oil cooler (D) forward to access the
radiator screen.
3. Lift the screen keeper handles (C) up and pull for-
ward. Remove the radiator screen and flush with
water or blow clean with air. Flush the radiator core
with water or blow clean with air. See engine owners
manual for proper radiator cleaning procedures.
4. Clean all dirt, grass, and debris from the oil cooler
fins.
5. Reinstall the radiator screen. Push the screen keep-
er handles back and down to retain the screen.
6. Pivot the oil cooler back and reinstall the wing bolt.
WARNING
PRESSURIZED SYSTEM
Hot coolant can cause serious burns. To open the
cooling system filler cap, stop the engine and wait
until the cooling system components are cool.
Loosen the cooling system pressure cap slowly
in order the relieve the pressure.
D
A
B
E
Figure 18. Radiator Overflow Bottle
C
Regular Maintenance