Filter
Top Products
9
Glow Plug Indicator
Indicates that the glow plugs are heating. Holding the
ignition key in the “HEAT” position until indicator starts to
glow, then turn the key to start.
PTO (Power Take Off) Switch
The PTO switch engages and disengages the mower.
Pull UP on the switch to engage the mower, and push
DOWN to disengage the mower.
Throttle Control
Moving the throttle control fully forward is FULL throttle
position. Always operate the unit at FULL throttle when
mowing.
Parking Brake
DISENGAGE Releases the parking brake.
ENGAGE Locks the parking brake.
Pull the parking brake lever back to engage the parking
brake. Move the lever fully forward to disengage the
parking brake.
NOTE: To start the unit the parking brake
must be engaged.
Deck Lift Pedal & Cutting Height
Adjustment Pin
These control the cutting height of the mower deck.
Depress the pedal until it locks into the TRANSPORT
position. Place the adjustment pin in the desired cutting
height and release the lift pedal.
Hour Meter
Measures the time of the PTO being engaged.
Voltmeter
Measures the battery voltage.
Water Temperature Gauge
Measures the engine coolant temperature.
Indicator Lights & Alarm
The indicator lights will illuminate and the alarm will
sound when the ignition switch is in the “ON” position
before cranking the engine. After the engine is running,
the indicator lights will illuminate and the alarm will
sound when there is either low oil pressure or high
coolant temperature.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the total fuel level of both tanks.
Hydraulic Oil Reservoir
Reservoir holds oil for the hydraulic ground drive sys-
tem. See REGULAR MAINTENANCE for oil level check
and fill procedure.
Features & Controls