Ferris Industries 5000/61R Lawn Mower User Manual


 
37
00
Troubleshooting, Adjustment & Service
5. See Figure 46. Measure the distance between the
rear lift pivots and the suspension-mounted lift pivots.
Add or remove 5/8” SAE washers from in between
the deck lift rod and the lift link until measurements
are equal.
Measure 1st
Add / Remove
5/8" SAE Washers
Measure 2nd
12"
30,5cm
Adjust Here
Adjust Here
Adjust Here
Figure 46. Lift Rod Adjustment
Figure 47. Deck Level & Spring Length Adjustment
6. Adjust the front eyebolts until the chains are tight and
the deck is still resting on the 2 x 4’s. Tighten jam
nuts. See Figure 47.
7. Loosen the nuts and allow the rear of the deck to
rest on the 2 x 4’s and 1/4” spacers. Slide the chains
down in the slots until the chains are tight and tight-
en the nuts. See Figure 47.
8. Remove all 2 x 4 blocks and spacers from under the
mower deck.
9. With the deck height adjustments complete and cut-
ting height still set at 4", adjust the deck lift spring to
a compressed length of 12" (30,5cm). Be sure to
measure the spring only. Adjust the length of the
deck lift spring by tightening or loosening the (2) 5/8”
hex nuts that are closest to the spacer at the front
end of the spring (see Figure 47). After adjustment
is made, tighten these two nuts together. Perform
this step to both springs.