Ferris Industries 5000/61R Lawn Mower User Manual


 
22
01
Regular Maintenance
GAS MODEL
CHECKING / ADDING FUEL
To add fuel:
1. Remove the fuel cap (see A, Figure 2).
2. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.
4. Repeat same process for opposite tank.
NOTE: The fuel supply to the engine is regulated by the
tank selector valve. Therefore, the fuel gauge will only
register the fuel level in the left-hand tank. It is str
ongly
recommended that the right-hand tank is used first so
when the tank is empty, switching over to the left-hand
tank will inform the operator of the remaining fuel avail-
able.
FUEL FILTER
The fuel filter is located in the fuel line between fuel shut
off valve and fuel pump, behind the hydraulic reservoir.
If filter is dirty or clogged, replace as follows:
1. Shut off the fuel tank selection valve.
2. Disconnect the negative battery cable.
3. Place a container below the filter to catch spilled fuel.
4. Using a pliers, open and slide hose clamps from fuel
filter.
5. Remove hoses from filter.
6. Install new filter in proper flow direction in fuel line.
7. Secure with hose clamps.
8. Reconnect the negative battery cable when finished.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the area.
Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage
could result.