Filter
Top Products
5
English
• Press control switch to off [O] position after cutting has stopped. With confetti-cut shredder,
cutting continues for several seconds after paper has gone through in order to clear shred-
ded paper from cutting cylinders.
CDs and DVDs
• Hold CD or DVD at the edge and feed one at a time, straight into CD entry (10), releasing
when shredding begins. Shredder will stop when CD has passed through entry. CDs will be
shredded into small particles.
CAUTION: Do not hold CD or DVD with finger through the center ring while feeding into
shredder.
In case of a
paper jam
, which may occur if the sheet capacity is exceeded or if paper is not
put in straight, turn off and empty the basket if full. Then:
1) Press and hold control switch in reverse [R] position and attempt to back paper out of
shredder.
2) If shredder jams in reverse mode, press control switch to automatic [I] position and
attempt to continue shredding operation.
3) If shredder jams again, alternate control switch slowly between reverse [R] and automatic
[I] positions to attempt to move jammed paper completely through shredder.
If you are unable to clear the jam using this method, turn off and unplug the shredder;
remove wastebasket from the cabinet and carefully remove any paper extending below the
cutting cylinders; insert wastebasket and repeat jam clearing procedure.
Maintenance
Regular emptying of the basket
is important to ensure the smooth operation of the cutting
cylinders. The shredder will not operate when the basket is full.
Regular oiling of the confetti-cut model
(SB-85C) is also necessary to ensure
proper performance. If you are running the shredder at or near capacity, we
recommend oiling it monthly. Using Fellowes Powershred Lubricant #35250 or
other non-aerosol vegetable-based oil in a long-nozzle container:
• Apply oil over full width of paper entry (1) with shredder in off [O] position.
• Press control switch to automatic [I] position which will cause shredder to run for about 2
seconds.
• Press and hold control switch in reverse [R] position for 3–5 seconds.
• Repeat above automatic [I] and reverse [R] sequence three times.
REMINDER:
Do not use flammable synthetic oil, petroleum-based products or
aerosol lubricants of any kind in or near the shredder at any time.
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If you
cannot solve the problem this way, contact Fellowes Customer Service.
Do not open shred-
der head
to attempt repair: It could expose you to serious electric shock and will void your
warranty.