Filter
Top Products
Operation
Figure 10
Honda unit
1. Mufer
2. Oil ll/dipstick
3. Fuel tank cap (fuel tank varies)
4. Recoil starter handle (located on handle bar for zone
start units)
5. Engine stop switch (if equipped)
6. Air lter
7. Choke
8. Spark plug
Figure 11
Kawasaki units with large fuel tank shown
1. Mufer
2. Oil ll/dipstick
3. Recoil starter handle
4. Fuel tank cap (fuel tank varies)
5. Engine stop switch (if equipped)
6. Throttle-Choke (if equipped)
7. Throttle Only (if equipped)
8. Oil lter
9. Air cleaner
10. Primer bulb (if equipped)
11. Spark plug
2. Open the fuel valve.
3. For EC21KABBCX Unit: Move the choke
control to the Choke position
For EC21KABBC Unit: Turn the engine stop
switch to “|” (see Figure 5).
For EC21KABBC, EC21KABBCCA,
EC21KABBCY, EC21KAX, EC21KACA, and
EC21KAY Units: Press the primer bulb two
times (see Figure 12).
Figure 12
For EC21HNBBC and EC21HNBBCX Units:
Turn the engine stop switch to “|” and pull
outward on the choke control.
Note: Do Not use the choke when the engine
is warmed up.
4. For units without a Blade Brake Clutch: Hold
the blade control bail to the handle.
5. Pull the starter handle lightly until you feel
resistance, then pull it sharply. Allow the rope to
return slowly.
6. For EC21KABBCCA, EC21KABBCX and
EC21KABBCY Units: When the engine starts,
move the throttle control to the Fast position.
7. For EC21HNBBC and EC21HNBBCX Units:
Gradually push in the choke control as the engine
warms up.
Stopping the Engine
1. Bring the unit to a full stop.
• For units without a Blade Brake Clutch:
Release the blade control bail. Both the
engine and the blade should stop within three
seconds.
• For units with a Blade Brake Clutch:
Release the blade control bail and the blade
control lock lever resets. The blade should
stop within three seconds; the engine will
continue to run.
16