Filter
Top Products
MQL • FEATURES AND BENEFITS
4
Designed For Maximum
Flexibility
The ENVIRO-TEC
®
Model MQL
Blower Coil Unit is designed to
maximize flexibility of selection
and installation.
The unit is also designed to exceed
the stringent quality standards of
the institutional market, while
remaining cost competitive in the
light commercial segment of the
market.
ENVIRO-TEC
®
Model MQL sets the
new standard for quality, flexibil-
ity, and competitive pricing.
For the Building Designer:
OPTIONAL COMPONENTS
MEAN FLEXIBILITY
The extensive variety of standard
options available on the MQL is
where you find the versatility to
fit any HVAC system designer’s
needs.
Options include: Mixing boxes
with standard low leak dampers,
High efficiency filter sections for
2" prefilter and 4" final filter, blow
thru electric heat with single point
power connection. All electric
heat units are listed with ETL as
an assembly and carry the cETL
label.
High Efficiency motors, starters,
disconnects and fusing mean eas-
ier coordination between mechan-
ical and electrical trades.
Coil options allow for 4 or 6 row
cooling coils. Water coils have
optional circuiting that can be
used to reduce Water Pressure
Drop, which may also allow for
pipe size reductions and lower
material cost. Hot Water or
Standard Steam coils may be
placed in the Preheat or Reheat
position.
All Model MQL blower coils have
the option of foil faced insulation.
For the Contractor:
L
OWER INSTALLED COST
Model MQL blower coils are
shipped completely assembled,
reducing field installation time
and labor. All units are thor-
oughly inspected and tested prior
to shipment, eliminating potential
problems at startup. Motor wiring
is brought to a junction box on the
outside of the unit casing, reduc-
ing electrical hook-up time.
A wide variety of fan discharge
configurations allow for increased
flexibility and easier installation on
the jobsite, resulting in cost reduc-
tions by eliminating expensive
elbows, etc.
For the Owner:
QU
ALITY PRODUCT
Model MQL blower coil units are
built from G60 minimum spangled
galvanized steel with a chromate
coating. This metal surpasses the
ASTM 125 hour salt spray test for
corrosion and rust. Standard insu-
lation is 1 inch fiberglass insulation
which is glued and pin spotted for
maximum positive adhesion.
Insulation complies with UL 181
and NFPA 90A.
All units, with or without Electric
Heat, are ETL listed and labeled.
All wiring is in compliance with
NEC, assuring safety and quality
for the owner.
ENVIRO-TEC