Filter
Top Products
5. Gently snug all flange screws to the
motor hub, working around the hub in a
clockwise sequence. Next, securely
tighten all flange screws, again working
in a clockwise sequence. Failure to
follow this procedure could result in fan
wobble. This completes the blade
installation.
NOTE: If you wish to assemble your
ceiling fan without the lower light
installed, skip steps 6 and 7, and
proceed to install the switch cup
assembly in accordance with steps 8
and 9.
6. Remove the plastic plug from the
center hole in the switch cup assembly.
Pass the two light fitter wires through
the center hole, then screw the switch
cup assembly onto the light fitter
threaded nipple (Figure 3). Install a
lockwasher and 1/8-27 nut (supplied)
on the threaded nipple to secure the
switch cup assembly to the decorative
ring/light fitter assembly.
7. Connect the white wire from the light
fitter to the white wire in the switch cup
assembly (Figure 3). Connect the black
wire from the light fitter to the blue wire
in the switch cup.
6
FAN
BLADE
BLADE FLANGE
10-24 X 8mm PAN
HEAD SCREW (3)
FLAT WASHER (3)
Figure 1
NOTCH
1/4-20 x 13mm OVAL HEAD
SCREWS (2)
BLADE
FLANGE
MOTOR HUB
SWITCH CUP PLATE
Figure 2
SWITCH CUP
ASSEMBLY
WHITE WIRE
1/8-27 NUT &
LOCKWASHER
BLUE
WIRE
BLACK WIRE
WHITE WIRE
DECORATIVE RING/LIGHT
FITTER ASSEMBLY
LIGHT
FITTER
Figure 3
2. Remove and discard the four shipping
retainers securing the motor hub in the
motor housing.
NOTE: Take care not to scratch the fan
housing when installing the blade
assemblies.
3. Insert an 1/4-20 x 13mm oval head
screw (supplied) into each of the two
recessed holes in one of the blade
flanges.
4. Rotate the motor hub so that two
threaded holes line up with the two
notches in the switch cup plate
(Figure 2). Position the blade flange on
the motor hub so that the screws in the
blades flange align with the two
threaded holes in the motor hub.
Loosely tighten the screws at this time.
Repeat this procedure for the
remaining four blade assemblies.
U.L. Model No.: CF220
BP7360 JULIANNE 9/19/07 11:15 AM Page 6