Filter
Top Products
20
en
OPERATION
1. Fill the oil tank every time engine is fueled. Chain saw should
use approximately one tank of oil per tank of fuel.
2. The automatic oil pump is a positive displacement pump
operated through gears driven off the clutch drum assembly.
The pump will not oil at idle speeds.
Preparation for Cutting
Proper Grip on Handles.
Refer to Safety Section for appropriate Safety Equipment.
1. Wear non-slip gloves for maximum grip and protection.
WARNING: Hold the saw firmly with both hands.
Always keep your LEFT HAND on the front handlebar
and your RIGHT HAND on the rear (throttle) handle
as shown in Fig. 41, so that your body is to the left of
the chain line. Never use a cross-handed grip, or any
stance which would place your body or arm across
the chain line. Left-handers should follow these
instructions too.
2. Maintain a proper grip (B, Fig. 42) on the saw whenever the
engine is running. The fingers should encircle the handlebar
and the thumb is wrapped under the handlebar. This grip is
least likely to be broken (by a kickback or other sudden reaction
of the saw). Any grip in which the thumb and fingers are on the
same side of the handle
(C), is dangerous because a slight kick
of the saw can cause loss of control.
WARNING:
Proper Cutting Stance (Fig. 43)
- Weight should be balanced on both feet - feet on
solid ground.
- Keep arm with elbow locked in a "straight arm"
position (D) to withstand any kickback force.
- Your body should always be to the left of the chain
line (E).
- Thumb on underside of handlebar (F).
Basic Cutting Procedure
Practice cutting a few small logs using the following technique to
get the "feel" of using your saw before you begin a major sawing
operation.
1. Take the proper stance in front of the wood with the saw idling.
2. Accelerate the engine to full throttle just before entering the cut
by squeezing the throttle trigger.
3. Begin cutting with the saw against the log.
4. Keep the engine at full throttle the entire time you are cutting.
5. Allow the chain to cut for you; exert only light downward pres-
sure. If you force the cut, damage to the bar, chain, or engine
can result.
6. Release the throttle trigger as soon as the cut is completed,
allowing the engine to idle.
If you run the saw at full throttle
without a cutting load, unnecessary wear or damage can
occur to the chain, bar, and engine.
7. Do not put pressure on the saw at the end of the cut.
ƽ
ƽ
41
42
43