Filter
Top Products
17
MOWING TIPS
• Mower should be properly leveled for
best mowing performance. See “TO
LEVEL MOWER HOUSING” in the
Service and Adjustments sec tion of this
manual.
• The left hand side of mower should be
used for trim ming.
• Drive so that clippings are dis charged
onto the area that has already been
cut. Have the cut area to the right of
the tractor. This will result in a more
even dis tri bu tion of clippings and more
uniform cutting.
• When mowing large areas, start by
turning to the right so that clippings will
discharge away from shrubs, fences,
driveways, etc. After one or two rounds,
mow in the opposite direction making
left hand turns until fi nished.
00272
MULCHING MOWING TIPS
IMPORTANT: For best performance, keep
mower housing free of built-up grass and
trash. Clean after each use.
• The spe cial mulch ing blade will recut
the grass clip pings many times and
reduce them in size so that as they fall
onto the lawn they will disperse into
the grass and not be noticed. Also, the
mulched grass will biodegrade quick ly
to provide nutrients for the lawn. Always
mulch with your highest engine (blade)
speed as this will pro vide the best recut-
ting action of the blades.
• Avoid cutting your lawn when it is wet.
Wet grass tends to form clumps and
in ter feres with the mulch ing action. The
best time to mow your lawn is the early
af ter noon. At this time the grass has
dried, the newly cut area will not be
exposed to direct sunlight.
• For best results, adjust the mower
cutting height so that the mower cuts
off only the top one-third of the grass
blades. For ex tremely heavy grass,
re duce your width of cut on each pass
and mow slow ly.
mulcher_9
Max 1/3
• If grass is extremely tall, it should be
mowed twice to reduce load and pos-
sible fi re hazard from dried clip pings.
Make fi rst cut relatively high; the second
to the desired height.
• Do not mow grass when it is wet.
Wet grass will plug mower and leave
undesirable clumps. Allow grass to dry
before mowing.
• Always operate engine at full throt tle
when mowing to assure better mow-
ing performance and proper dis charge
of material. Regulate ground speed by
se lect ing a low enough gear to give the
mower cut ting per for mance as well as
the quality of cut desired.
• Certain types of grass and grass
con di tions may re quire that an area be
mulched a second time to com pletely
hide the clippings. When doing a sec-
ond cut, mow across or (per pen dic u lar)
to the fi rst cut path.
• Change your cutting pattern from week
to week. Mow north to south one week
then change to east to west the next
week. This will help prevent matting and
graining of the lawn.
8. Slowly move motion control lever
forward, after the tractor moves ap-
prox i mate ly fi ve (5) feet, slowly move
motion control lever to reverse po si tion.
After the tractor moves ap prox i mate ly
fi ve (5) feet return the motion control
lever to the neutral (N) position. Repeat
this pro ce dure with the motion control
lever three (3) times.
Your transmission is now purged and
ready for normal operation.
• When operating attachments, se lect a
ground speed that will suit the terrain
and give best performance of the at-
tach ment being used.