Filter
Top Products
24
3. Use the wooden stick or brush to remove dirt form cylinder fins.
IMPORTANT
Do not use a metal scraper to remove dirt from the cylinder fins.
4. Remove grass and leaves from the grid between the recoil starter and
fuel tank.
5. Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the engine cover.
EXHAUST SYSTEM
Spark Arrestor Screen
Level 2.
Tools required: Cross Head Screwdriver, 3 mm Hex Wrench, Soft
Metal Brush, Wooden Carbon Scraper.
Parts Required: Screen P/N 14586240630, Gasket P/N 14586642031
1. Remove engine cover (A). See “Cleaning Cooling System” pages
26 & 27 for step by step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3. Remove spark arrestor screen cover (B), screen holder (C), gasket
(D) and screen (E) from muffler body.
4. Clean carbon deposits from muffler components.
5. Replace screen if it is cracked, plugged or has holes burned through.
6. Assemble components in reverse order
NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the engine cover.
E
D
C
B