Echo SRM - 2110 Brush Cutter User Manual


 
G
RASS
T
RIMMER
/B
RUSH
C
UTTER
O
PERATOR
'
S
M
ANUAL
5
EQUIPMENT
Before operation a complete check of the unit must be performed;
Check unit for loose/missing nuts, bolts and screws. Tighten and/or
replace as needed.
Inspect fuel lines, tank and area around carburetor for fuel leaks.
DO NOT operate unit if leaks are found.
Inspect shield for damage and ensure that the cut-off knife is
securely in place. Replace if either is damaged or missing.
Check that the cutting attachment is firmly attached and in safe
operating condition.
Check that front (loop) handle and shoulder strap/ or shoulder/waist
harness are adjusted for safe, comfortable operation. See Assembly
Section on page 16 for proper adjustment.
3 M
(10 FT.) MINIMUM
FUEL
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result
Use an approved fuel container.
DO NOT smoke near fuel.
DO NOT allow flames or sparks near fuel.
Fuel tanks/cans may be under pressure. Always loosen fuel caps
slowly allowing pressure to equalize.
NEVER refuel a unit when the engine is HOT!
• NEVER refuel a unit with the engine running.
DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks
outdoors over bare ground.
Securely tighten fuel cap after refueling.
Inspect for fuel leakage. If fuel leakage is found, do not start or
operate unit until leakage is repaired.
After Refueling;
Wipe any spilled fuel from the unit.
Move at least 3 m (10 ft.) from refueling location before starting.
After Use;
DO NOT store a unit with fuel in its tank. Leaks can occur. Return
unused fuel to an approved fuel storage container.