Filter
Top Products
G
RASS
T
RIMMER
/B
RUSH
C
UTTER
O
PERATOR
'
S
M
ANUAL
15
Install Harness Clamp
NOTE
Some models require installation of Harness Clamp. If your unit
does not have a clamp, follow these directions.
Tools Required: Screwdriver, 8mm x 10mm Open End Wrench.
Parts Required: Clamp, 4mm x 18mm Hexagon Head, Bolt, Link.
6. Remove shield and gear housing as an assembly.
a. Loosen two (2) screws that clamp the gear housing to the
drive shaft housing.
b. Remove locating screw found at the top of the gear housing.
Pull shield and gear housing assembly from the drive shaft
assembly.
IMPORTANT
Prevent flexible drive cable from sliding from drive shaft housing.
If cable does slide free, clean dirt from cable and lubricate with
lithium based grease prior to re-assembly.
7. Remove front handle.
a. Remove four (4) screws and nuts and handle support from
front handle.
b. Remove front handle.
8. Install clamp.
- Slightly spread clamp and slide up shaft.
- Install single link using spacer, DO NOT tighten at this time.
9. Install gearbox, shield and front handle.
10.Balance unit.
a. Put on harness and attach unit to harness.
b. Slide clamp up or down until unit balances with head
approximately 2" - 3" from the ground.
c. Tighten clamp screw.
2 ~ 3"