Filter
Top Products
GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
15
B
A
PLASTIC SHIELD INSTALLATION
(for Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 15mm
screws.
NOTE
The plastic shield is for use with the Nylon Line Head only.
Install Metal Shield when using plastic or metal blades.
1. Remove plastic threaded shaft sleeve and adapter plate from PTO
shaft.
2. Snap the shield on the bottom of the bearing housing flange.
3. Place shield plate on shield, align holes. Install three (3) screws
from bottom through plate and shield into gearcase.
4. Reassemble adapter plate onto threaded shafts
NYLON LINE HEAD INSTALLATION
Tools Required: Head Locking Tool,
Parts Required: Nylon Line Head.
1. Remove plastic sleeve from gear housing shaft.
2. Be sure plate (A) remains on PTO shaft.
3. Align locking hole in upper plate with notch in edge of gear
housing and insert head locking tool (B).
4. Thread line head onto shaft by turning it counter clockwise until
head is tight against upper plate.
FRONT HANDLE INSTALLATION
Tools Required: Screwdriver.
Parts Required: Front Handle Assembly
1. Position front handle for comfortable operation and secure screws.