Filter
Top Products
GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
27
3. Use one piece of nylon line (D) and thread through the molded loop
(E) on the spool spindle until ends are even.
4. Hold spool with the tap knob in your hand and opening toward
you. Place index finger between the two lines, and wind line
clockwise tightly and evenly.
5. When approximately 15-20 cm ( 6- 8 in.) of line remains, place lines
in spool notches (F).
6. Thread line ends through housing eyelets (G) and place spool in
housing against spring.
7. Align cover tabs with tab holes in housing and push cover on until
tabs snap-lock into place.
8. Pull on both lines until they come free from notches in spool.
9. Index line out by pushing tap knob and trim line to cut-off knife
length.
E
F
F
G
G
D