Filter
Top Products
GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
33
NOTE
Every unit is run at the factory and the carburetor is set in compli-
ance and California Emission Regulations. In addition, the carbure-
tor is equipped with a HI needle adjustment limiter that prevents
settings outside acceptable limits.
1. Before adjusting the carburetor, clean or replace the air filter and
spark arrester screen.
2. Trimmer line must be extended to the cut-off knife.
3. Start engine and run for several minutes to reach operating tempera-
ture.
4. Stop engine. Turn HI speed needle (A) CCW (counter clockwise) to
stop.
5. Idle Speed Adjustment.
• Start engine and turn “idle” speed adjustment screw (B) CW
until the blades begin to turn, then turn the screw CCW until
blades stop turning. Turn screw CCW an additional 1/4 turn.
6. Accelerate to full throttle for 2-3 seconds to clear excess fuel from
engine then return to idle. Accelerate to full throttle to check for
smooth transition from idle to full throttle. If engine stops or stalls
after full warm up return the unit to your authorized ECHO dealer for
repair.
7. Check HI speed RPM at W.O.T. (Wide Open Throttle). HI speed
RPM should be set to specifications found on page 14 "Specifica-
tions" of this manual.
8. Check idle speed and reset if necessary. If a tachometer is available,
idle speed should be set to the specification found on page 14
"Specifications" of this manual.
WARNING DANGER
When carburetor adjustment is completed, the cutting attachment
should not turn at idle, otherwise serious personal injury may
result.
B
A