Filter
Top Products
GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
15
PLASTIC SHIELD INSTALLATION
(for Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 15mm
screws.
NOTE
The plastic shield is for use with the Nylon Line Head only.
Install Metal Shield when using plastic or metal blades.
1. (SRM-211U) Remove split pin, blade nut, lower and upper plate from
PTO shaft.
1. (SRM-211) Remove plastic sleeve and upper plate (A) from PTO
shaft.
2. Install the shield on the bottom of the bearing housing flange.
3. Place shield plate (B) on shield, align holes and install three (3)
5x15 mm screws.
4. Install upper plate (A).
NYLON LINE HEAD INSTALLATION
Tools Required: Head Locking Tool, 17x19mm Scrench
Parts Required: Nylon Line Head.
1. (SRM-211) Align hole in upper plate with notch in edge of gear
housing and insert head locking tool (C). Remove plastic sleeve
from PTO shaft.
2. (SRM-211U) Remove split pin from hole in PTO shaft.
3. (SRM-211U) Remove 10mm nut by turning it clockwise (as viewed
from underside of grass shield) with 17x19mm scrench.
4. (SRM-211U) Remove lower plate. Retain lower plate, 10mm nut and
split pin for future use.
5. Be sure upper plate (A) remains on PTO shaft.
6. Thread line head onto PTO shaft by turning it counter clockwise
until head is tight against upper plate.
7. Remove locking tool (C).
ASSEMBLY
WARNING DANGER
Use only ECHO approved attachments for these models. Serious injury may result from the use of non approved
attachment combinations. Read and comply with all safety instructions listed in this manual and attachment manual.
ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been
tested and approved by ECHO for use with these units.
B
A
C