Filter
Top Products
26
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
WARNING DANGER
The cutting attachment should not rotate at idle. If attachment
rotates, readjust carburetor according to "Carburetor Adjustment"
instructions in this manual or see your ECHO Dealer, otherwise
serious personal injury may result.
1. Stop Switch - Start/Run. Move Stop Switch button (A) away from
the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible
in the "Clear" fuel return line. Pump bulb an additional 4 or 5 times.
3. Start - Pull Rope. Lay the trimmer on a flat clear area and pull
the recoil starter handle (D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
A
D
C