Filter
Top Products
8
SPECIFICATIONS
PAS Articulating Hedge Clipper Attachment
Shaft Length ------------------------------------------------1282.7 mm (50.5 in.)
Attachment Width -----------------------------------------114.30 mm (4.50 in.)
Height ------------------------------------------------------- 92.1 mm (3.63 in.)
Weight ------------------------------------------------------2.73 kg. (6.02 lb.)
Gear Case Ratio -------------------------------------------- 3.5 : 1
Cutter -------------------------------------------------------- Double Reciprocating Blade - Double Edge
Effective Length ----------------------------------------- 411 mm (16.2 in.)
Pitch ------------------------------------------------------- 35 mm (1.4 in.)
Maximum Diameter Cut
Soft Material ---------------------------------------------- 25.4 mm (1 in.)
Woody Material ------------------------------------------ 13 mm (1/2 in.)
ASSEMBLY
POWER
HEAD SHAFT/LOWER SHAFT ASSEMBLY
Tools Required: None
Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock-
out position.
3. Carefully fit attachment drive shaft assembly into coupler (B) to
decal assembly line (C), making sure that the inner lower drive shaft
engages into the square upper drive shaft socket.
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings fit flush to decal point (E). New couplings are 4-3/4 in.
long, and fit flush to line (C).
4. Select desired blade position by aligning one of the holes (F) in
lower shaft with locator pin position.
5. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap flush in coupler. Full engagement
will prevent further shaft rotation.
6. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
A
B
D
F
E
D
C
C
A