Filter
Top Products
Sh a f t he d g e Cl i p p e r
27
Op e r a t O r ’S Ma n u a l
IMPORTANT
Always store and transport shaft hedge clippers in a stable, horizontal position. Always install blade cover, and
return cutting assembly to folded/locked position for travel/storage.
Long Term Storage (over 30 days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte-
nance which includes the following:
1. Store unit in a dry, dust free place, out of the reach of children.
WARNING
During operation the mufer or catalytic mufer and surrounding cover become hot. Always keep exhaust area clear
of ammable debris during transportation or when storing, otherwise serious property damage or personal injury
may result.
st o r a g e
DANGER
Do not store in enclosure where fuel fumes may accumulate or reach an open ame or spark or serious personal
injury may result.
2. Place the stop switch in the “OFF” position.
3. Remove accumulation of grease, oil, dirt and debris
from exterior of unit.
4. Perform all periodic lubrication and services that are
required.
5. Apply a light coating of clean 20W engine oil along
entire length of blades and on blade bolts.
6. Install blade cover.
7. Tighten all the screws and nuts.
8. Drain the fuel tank completely and pull the recoil
starter handle several times to remove fuel from the
carburetor.
9. Remove the spark plug and pour 7 cc (1/4 oz.) of
fresh, clean, two-stroke engine oil into the cylinder
through the spark plug hole.
A. Place a clean cloth over the spark plug hole.
B. Pull the recoil starter handle 2-3 times to distrib-
ute the oil inside the engine.
C. Observe the piston location through the spark
plug hole. Pull the recoil handle slowly until the
piston reaches the top of its travel and leave it
there.
10. Install the spark plug (do not connect ignition cable).