Filter
Top Products
HEDGE CLIPPER
OPERATOR'S MANUAL
17
1. Disconnect spark plug lead from spark plug.
2. Remove (1) screw from top guard, and remove guard.
3. Remove (4) screws from engine/muffler cover, and remove cover.
4. Use the brush to remove dirt form cylinder fins.
5. Remove grass and leaves from the grid between the recoil starter
and fuel tank.
6. Assemble components in reverse order.
NOTE
When installing the engine/muffler cover, be certain the tabs of the
metal deflector shield are in the slots of the cover.
EXHAUST SYSTEM
Spark Arrestor Screen
Level 2.
Tools Required: Cross head screwdriver, soft metal brush.
Parts Required: Spark Arrestor Screen P/N 14586240630,
Gasket P/N 14586642031
1. Remove engine/muffler cover (A). See "Cleaning Cooling System"
pages 16 and 17 for step by step instructions.
2. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3. Remove spark arrestor screen cover (B), gasket (C), and screen (D)
from muffler body.
4. Clean carbon deposits from muffler components.
5. Replace screen if it is cracked, plugged or has holes burned
through.
B
C
D
A