Filter
Top Products
10
ASSEMBLY
Tools Required: 4 mm hex wrench, screwdriver
Parts Required: Power Head/Drive Shaft Assembly and
Gear Housing Assembly
GEAR HOUSING ASSEMBLY/DRIVE SHAFT
WARNING DANGER
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1. Remove protective cap from drive shaft end.
2. Remove locating screw (A) and align the locating hole in the gear
case with the locating hole (B) in the drive shaft housing.
3. Slide the gear housing assembly on the drive shaft. Be certain the
flex drive shaft engages the hole in driver gear and install locating
screw (A).
4. Tighten screw (A) and clamping bolts (C).