Filter
Top Products
5
CS-510
NOMENCLATURE HAVE PARTS
1. Operator’s manual - Included with unit.
Read before operation and keep for future
reference to learn proper, safe operating
techniques.
2. Installation and use KICK GUARD -
Describe how to install the kick guard and
operate the saw with kick guard.
3. Safety manual - Describe operating and safety
instructions for this chain saw.
4. Front hand guard - Guard between the front
handle and the saw chain for protecting the
hand from injuries and aiding in control of the
chain saw if the hand slips off the handle.
This guard is used to activate the chain
brake which is to stop the saw chain rotation.
5. Air cleaner cover - Covers air filter.
6. Rear handle (for the right hand) - Support
handle located towards the rear of the
engine housing.
7. Choke control knob - Device for enriching the
fuel/air mixture in the carburettor to aid cold
starting.
8. Rear hand guard - Extension on the lower part
of the rear handle for protecting the hand
from the chain if it breaks or degrooves.
9. Clutch cover - Protective cover to the guide
bar, saw chain, clutch and sprocket when the
chain saw in use.
10. Chain catcher - A safety projection designed
to reduce the risk of the operator’s right hand
from being hit by a chain which has broken
or derailed from the guide bar during cutting.
11. Guide bar - The part that supports and guide
the saw chain.
12. Bar tip guard - Anti-kickback device attached
on the bar nose.
13. Saw chain - Chain, serving as a cutting tool.
14. Spiked bumper - Device, fitted in front of the
guide bar mounting point, acting as a pivot
when in contact with a tree or log.
15. Front handle ( for the left hand ) - Support
handle located at the front of the engine
housing.
16. Oil tank cap - For closing the oil tank.
17. Fuel tank cap - For closing the fuel tank.
18. Throttle trigger - Device activated by the
operator’s finger, for controlling the engine
speed.
19. Throttle trigger lockout - A safety lever which
must be depressed before the throttle trigger
can be activated in order to prevents the
accidental operation of the throttle trigger.
20. Ignition switch - Device for connecting and
disconnecting the ignition system and thus
allowing the engine to be started or stopped.
21. Starter handle - Pull handle slowly until starter
engages then quickly and firmly. When
engine starts, return handle slowly.
DO NOT let handle snap back or damage to
unit will occur.