Filter
Top Products
10
CS-510
OPERATION
WHEN THE ENGINE IS COLD
• Fill the fuel tank with fuel.
• Fill the chain oil tank with lubricant.
• Press hand guard forward. (Chain brake
ACTIVATED position)
• Turn ignition switch upside. (“RUN” position)
• Pull choke control knob all the way out. (Choke
position)
CAUTION
Make sure bar and chain are free from any
obstruction when starting the saw.
• Make sure guide bar and saw chain are not
touching anything when starting the saw.
• Securely hold the saw as shown and pull starter
handle several times until first firing sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
• When engine starts, immediately pull throttle
trigger up to release the latch, then release
throttle trigger.
CAUTION
The chain will attempt to rotate when engine is
started with throttle latch engaged.
After engine starts, release throttle trigger to idle
engine, otherwise brake damage may occur.
Never use the latch for cutting.
Use it only when starting the engine.
WHEN THE ENGINE IS WARM
• Confirm fuel and chain oil in the tanks.
• Press hand guard forward. (Chain brake
ACTIVATED position)
• Turn ignition switch upside. (“RUN” position)
• Make sure guide bar and saw chain are not
touching anything when starting the saw.
• Securely hold the saw as shown and pull
starter handle.
• Choke may be used if necessary but after first
firing sound, pull throttle trigger a little to release
throttle locking and choke.
Choke
Stop switch
Open
Chain brake
Start