Filter
Top Products
23
CS-510
AREA MAINTENANCE PAGE
Air Filter Clean •
Replace 18 •
Fuel Filter Clean
Replace 19 •
Spark Plug Clean •
Replace 18 •
Carburettor Check/Rebuild •
Replace 17 1 •
Cooling System Inspect/Clean 18 •
Muffler Inspect/Clean - •
Oil Filter Inspect/Replace 19 •
Sprocket Inspect/Replace 20 •
Starter Rope Inspect/Replace - •
Guide Bar Inspect/Clean 20 •
Fuel System Inspect/Repair - •
Screws, Bolts & Nuts Inspect, Tighten/Replace •
Choke System Check 10 •
Ignition System Clean/Replace NO MAINTENANCE REQUIRED FOR COIL AND FLYWHEEL
Plug
Air cleaner cover
Snow Protector
(Option part)
IMPORTANT
Time intervals shown are maximum.
Actual use and your experience will determine
the frequency of required maintenance.
Replacement will be required for commercial use
after 600 hours.
For consumer use, cleaning every 6 months is
required.
Cleaning includes Rebuild kits.
Every year or
600 Hours use
Daily or every
4 Hours use
With Each
Re-Fueling
Before use
Monthly
Every Three Months
or 100 Hours use
Six Months or
300 Hours use
WINTER KIT
Use the winter kit with chain saw to prevent a
carburettor’s trouble in winter season.
Installation of the kit is as follows.
• AIR CLEANER COVER - Remove air cleaner
cover. Remove plug provided inside of the cover.
• SNOW PROTECTOR (Option) - Snow protector
prevents that snow gets into the unit by fan cover
in snow fall or laying snow.
• Set the protector hook (2pcs) to the fan cover.
Ensure that the setting direction is correct as
shown.
• Tighten two screws to fasten the snow protector.
CAUTION
Do not use these parts in normal temperature.
It causes over heating of the engine.
SERVICE GUIDE
1