Filter
Top Products
2
5.Do not allow other persons to be near
the chain saw when starting or cutting
with the chain saw.
Keep bystanders and animals out of the
work area.
6.Do not start cutting until you have a
clear work area, secure footing, and a
planned retreat path from the falling
tree.
7.Keep all parts of your body away from
the saw chain when the engine is
running.
8.Before you start the engine, make sure
that the saw chain is not contacting
anything.
9.Carry the chain saw with the engine
stopped, the guide bar and saw chain
to the rear, and the muffler away from
your body.
10.Do not operate a chain saw that is
damaged, improperly adjusted, or not
completely and securely assembled.
Be sure that the saw chain stops
moving when the throttle control trigger
is released.
11.Shut off the engine before setting the
chain saw down.
12.Use extreme caution when cutting
small size brush and saplings because
slender material may catch the saw
chain and be whipped toward you or
pull you off balance.
13.When cutting a limb that is under
tension, be alert for springback so that
you will not be struck when the tension
in the wood fibers is released.
14.Keep the handles dry, clean, and free of
oil or fuel mixture.
15.Operate the chain saw only in well
ventilated areas.
16.Do not operate a chain saw in a tree
unless you have been specifically
trained to do so.
17.All chain saw service, other than the
items listed in the Instruction manual
maintenance instructions, should be
performed by competent chain saw
service personnel.
(For example, if improper tools are
used to remove the flywheel or if an
improper tool is used to hold the
flywheel in order to remove the clutch,
structural damage to the flywheel could
occur and could subsequently cause
the flywheel to burst.)
18.When transporting your chain saw, use
the appropriate guide bar scabbard.
19.Spark arrestor mufflers approved to
SAE Standard J 335 are standard on
ECHO chain saws to reduce the
possibility of forest fires.
Do not operate the chain saw with a
loose or defective muffler.
Do not remove the spark arrestor
screen.