Filter
Top Products
10
OPERATION
WHEN THE ENGINE IS COLD
• Fill the fuel tank with fuel.
• Fill the chain oil tank with lubricant.
• Turn switch to “RUN” position.
• Pull choke control knob all the way out.
(Choke position)
CAUTION
Make sure bar and chain are free from any
obstruction when starting the saw.
• Securely hold the saw as shown and pull
starter handle several times until first firing
sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
WHEN THE ENGINE IS HARD TO
START
• Press throttle trigger lockout down while
grasping throttle trigger and push in latch.
• Pull starter handle.
• When engine starts, immediately pull throttle
trigger up, to release the latch.
Choke
Open
Start/Run
CAUTION
The chain will attempt to rotate when engine is
started with throttle latch engaged.
After engine starts, release throttle trigger to idle
engine, otherwise brake damage may occur.
Never use the latch for cutting.
Use it only when starting the engine.
Ignition switch
Choke control knob
Throttle lock
Throttle trigger lockout
Throttle trigger
PUSH
Choke control knob
CAUTION
1. When locking throttle trigger by throttle lock at
starting, keep the brake in brake position.
2. After starting the engine, squeeze throttle
trigger slightly to release locking and pull front
hand guard towards the operator immediately.
(Chain brake RELEASED position)
3. Do not increase engine speed while chain
brake is engaged.
4. Use the chain brake in an emergency. Do not
use it unless absolutely necessary.