Filter
Top Products
14
st o r a g e
1. Clean ProSweep attachment bristles with water.
IMPORTANT
Do not immerse this attachment in water. Water will enter gear
housing and damage gears, bearings and seals.
2. Apply thin coating of oil to metal parts to prevent rust.
3. Lubricate lower shaft assembly with grease. (Refer to Lubrication
instructions.)
4. Store ProSweep attachment in a dry place out of reach of children.
Do not store attachment with the weight resting on brushes which
could bend over a long period of time. Store attachment with
lower shaft housing in a horizontal or vertical position to prevent
grease loss from open shaft end.
Storage Hook Installation
5. Insert small end of hook into locating hole on attachment shaft.
6. Slide plastic cap onto end of attachment shaft.
sp e c I f I c a t I o n s
ProSweep Attachment : Approved for use on PAS and Split Boom Models
Attachment Length ---------------------------------------- 925 mm (36.4 in.)
Attachment Width ----------------------------------------- 598 mm (23.5 in.)
Attachment Height ----------------------------------------- 280 mm 11 in.)
Weight ------------------------------------------------------- 5.1 kg. (11.25 lb.)
Drive Shaft -------------------------------------------------- 6.35 mm (0.25 in.)
Rotating Direction ----------------------------------------- Towards the operators viewed from the rear
Brushes ------------------------------------------------------ Nylon Bristles 0.7 mm (0.028 in.) Nylon Bristles
Max Sweeping Width ------------------------------------- 590 mm (23.2 in.)
Gear Case Lubrication ------------------------------------ EP "0" or "00" Grease
Gear Reduction Ratio ------------------------------------- 42.75 : 1
Drive Shaft Lubrcation ------------------------------------ POWER BLENDX
TM
Sweeper Operating (RPM) ------------------------------- 210
Engine Wide Open Throttle (RPM) w/attachment ---- 7700-8500