Filter
Top Products
Sh a f t he d g e Cl i p p e r at t a C h m e n t
Op e r a t O r 'S ma n u a l
13
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Slide blades to allow le clearance using slots (B) on bottom of
blade. Do not pry against cutting edges.
4. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used DO NOT allow blade to over heat.
6mm (.25 in.) Radius
B
45º
5. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
A
b l a d e a d j u s t m e n t
Level 2.
Tools Required: 8 mm Socket & Extension, 4mm Hex Wrench w/
extension
1. Move stop switch to STOP position.
2. Disconnect spark plug wire.
WARNING
Hedge clipper blades are very sharp. Touching them may lead to
severe personal injury. Use long hex wrenches and sockets with
extensions when tightening blade screws and blade locknuts to keep
hands at a safe distance from sharp blades.
3. Tighten blade screws (A) securely.
4. Hold blade screws (A) to prevent turning, and tighten locknuts (B).
B