Filter
Top Products
12
A
B
C
C
D
A
B
WARNING
Blades are very sharp. Wear gloves to protect hands, otherwise
serious personal injury may result.
1. Remove gear housing locating screw (A) and loosen clamping
screw (B). Remove the gear housing assembly from the drive
shaft housing.
2. Pull the drive shaft (C) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the exible shaft back in the drive housing being careful not
to get dirt on the ex shaft.
4. Slide Gear Housing Assembly onto Drive Shaft. Be certain the
Flex Drive Shaft engages the hole in Driver Gear.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
5. Align locating hole in gear housing with locator hole in drive
shaft.
6. Install locating screw (A). Tighten clamping screw (B).
s h a r p e n I n g b l a d e s
Level 2.
Tools required: Flat le, Screwdriver
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.