Filter
Top Products
Sh a f t he d g e Cl i p p e r at t a C h m e n t
Op e r a t O r 'S ma n u a l
11
WARNING
Blades are very sharp. Wear gloves to protect hands, otherwise
serious personal injury may result.
1. Brush loose debris from blade and coat both sides of blade with the
50-50 cleaning mixture.
2. Allow cleaning mixture to soften the remaining gummy residue
then wipe it from the blade.
3. Apply clean oil to the entire length of the blade. Be certain the
blade bolts are lubricated.
4. Wipe excess oil from the blade before putting the unit back in ser-
vice.
A
Gear Housing Assembly
Level 2
Tools required: Grease gun, clean rag
Parts required: POWER BLENDX
TM
14 oz. cartridge P/N 91015 or
Lithium Based Grease
1. Clean dirt from grease tting (A).
2. Carefully pump grease in tting. DO NOT force grease.
Too much pressure will force grease past seals and cause damage.
Apply 1-2 pumps of grease every 15-25 hours of operation.
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: 4 mm hex wrench, clean rag, small brush
Parts required: POWER BLENDX
TM
8 oz. (P/N 91014) or
Lithium Based Grease.