Dyson AM 04 Patio Heater User Manual


 
4
5
Controls
Heating mode
Cool air mode
Power and remote controlTilt function
Remote control docks magnetically
Attach remote control to top of heater
with the buttons facing down.
To operate, point remote control toward the front of the base.
Carefully hold the base and the top of the air loop amplifier.
Tilt forward or backward for the required airflow angle.
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle
is complete, it will revert to the selected airflow speed.
On first use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.
1. Power on 2. Thermostat control 3. Airflow speed control 4. Oscillation control
Select the desired room temperature. Pressing red
increases the target temperature, blue decreases it.
The heater will not operate unless the target
temperature is above the room temperature.
To change the airflow speed press the airflow speed
control button. The digital display will show the new
speed; after 3seconds it will change back to the
target temperature.
To start the heater oscillating, press the oscillation
control button. The heater will not oscillate when the
control buttons are pressed.
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airflow speed use the airflow
speed control.
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.
For best results turn on the oscillation control.
Select a high flow of air.
Select a low flow of air.
To return to heating mode
Whole room
Spot heat
Stand by
on/off
Airflow speed
control
Oscillation
on/off
Thermostat
control