Dolmar MS-250.4 Brush Cutter User Manual


 
13
CORRECT HANDLING OF MACHINE
Attachment of shoulder strap
Adjust the strap length so that the cutter blade will be kept parallel with the
ground.
Detachment
For MS-251.4
In an emergency, push the notches (1) at both sides, and you can detach
the machine from you.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
For MS-250.4
In case of emergency, remove the emergency detachment lever (2) by
pulling strongly with a finger. The machine sill detach from body.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deflected toward you or anyone in the work
vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
POINTS IN OPERATION AND HOW TO STOP
Observe the applicable accident prevention regulations!
STARTING
Move at least 3m away from the place of refuelling. Place the brush cutter on a clean piece of ground taking care that the cutting tool does
not come into contact with the ground or any other objects.
A:Cold start
1) Set this machine on a flat space.
Throttle control dial
I-O switch (1)
OPERATION
Lock-off lever
High speed
Low speed
Throttle lever (6)
Hanger
(2)
Hanger