Dixon ZTR 7025 Lawn Mower User Manual


 
Page 11
CHASSIS: 11 GA - rectangular tube
BODY: Folded sheet metal.
SEAT: Designed for operator comfort with padded back and arm rests. Seat is adjustable
fore and aft.
MOWER DECK: 2 Decks are available. Both decks are made of 10 GA fabricated welded
construction with 7 GA reinforcement plate. 3 blades combine for either a 52" or
60" cut width. Cut height approximately 1.5" to 5" via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
ENGINE: 25HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-
Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase with Cast
Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel Pump,
Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel Filter,
Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
TIRES: Front 13-5.00x6
Rear 23-9.50x12
RECOMMENDED Front 12 lbs.
TIRE PRESSURE: Rear 12 lbs.
CAPACITIES: Fuel - 11 gallons (approx)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 61"(52" Deck), 69-1/2"(60" Deck)
Height 43"
Length 81" (52” Deck), 81” (60” Deck)
Weight 915 lbs.(48" Deck), 916 lbs.(60" Deck)
NOTE: Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SPECIFICATIONS
7000 Series