Dixon 4000 Series Lawn Mower User Manual


 
SPECIFICATIONS
Models ZTR 4423 & ZTR 4424
CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY: All body parts are made of high density polyethylene, dent and corrosion
resistant. Front body contains access panel for battery service.
MOWER DECK: 13 GA stamped steel construction.
[3] blades combine for a 42" cut width.
Cut height approximately 1" to 4" via 8 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by chain and sprockets through a
mechanical friction drive.
ENGINE:
Model 4423: 15HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder
Sleeve, Oil Pump With Integral Oil Filter.
Model 4424: 15HP Kohler Command 15, 4-Cycle, Single Cylinder, Overhead Valve,
Air-Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
Aluminum Head and Block with Cast-iron Cylinder Liner.
STARTING SYSTEM: Electric by key switch operation with safety interlock blade drive.
TIRES: Front 11 X 4.00 X 5 ribbed tread.
Rear 18 X 9.50 X 8 Turf Trac RS
RECOMMENDED
TIRE PRESSURE: Front 16-21 Ibs.
Rear 8-14 Ibs.
CAPACITIES: Fuel 2.7 gallons total.
Engine Briggs &. Stratton -1.50 quarts oil.
Kohler - 2 quarts oil with filter.
DIMENSIONS: Width 47" outside rear wheel measurement.
Height 42" to top edge of seat.
Length 72" hitch tab to front bumper.
Weight 520 Ibs.
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 10