Filter
Top Products
CONTROLS
Dixon-23
Fuel Shut Off Valve
The fuel shut off valve is located at the left rear of the
seat. The valve is off when the handle tab is turned
perpendicular to the fuel line.
8011-419
Fuel shut off valve in the CLOSED position
Cutting Height Adjuster
The deck cutting height is obtained by pressing the
foot pedal forward to lift the deck. To lower the deck,
apply pressure to the top side of the foot pedal and
allow it to pivot while the lift arm rotates to the rear of
the unit. To stop in the desired cutting position, rotate
the foot pedal down into the notch in the height plate.
The cutting height range is from 1½" (38mm) to 4½"
(114mm) in ¼ (6mm) increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
8050-117
The mower deck’s lifting lever
IMPORTANT INFORMATION
In order to obtain an even cutting height, it is
important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.