DeWalt H1000IS Portable Generator User Manual


 
13- ENG
D28469
5. Place skyhook on the fuel tank
side of the frame and install
upper bracket as shown.
6. Wrap upper bracket around
frame.
7. Slide lockwashers onto bolts,
insert through brackets, and
secure with whizlock nuts.
NOTE: DO NOT tighten bolts at
this time.
8. Repeat steps 5-7 on other side.
9 Position skyhook between
arrows on label. NOTE: Bracket
should not overlap onto weld (a).
Failure to properly
position skyhook
can cause property damage,
serious injury or death, and void
the manufacturer’s warranty.
10. Torque four bolts to 11-12 ft.-lbs.
(132-144 in.-lbs.)
IMPORTANT: DO NOT substitute
hardware when assembling the
skyhook.
11. Place tank on frame rails and
align holes in tank with holes in
frame.
12. Install fuel tank screws and
washers. Torque screws to 20-
25 inch pounds (hand tight).
13. Open the fuel shut-off valve. Turn
counter clockwise until the valve
stops.
a