Filter
Top Products
9- ENG
D28469
NOTE: This manual is a general manual. Information in this manual may or
may not pertain to your model. Please read carefully.
NOTE: Left and right describes the location of a part with the operator
facing the outlet panel.
ASSEMBLY
Read this manual. Do not attempt to operate equipment
until you have read this Manual for Safety, Operation, and
Maintenance Instructions.
UNPACKING
1. Locate the parts carton and set aside
for later use.
2. Cut wire ties holding generator to
pallet and remove protective
wrapping.
3. Remove all packaging, leaving
generator on pallet.
IMPORTANT: DO NOT remove generator from
pallet.
4. Discard all packaging.
Wire Tie
Protective
Wrapping
ASSEMBLE WHEEL KIT
Tools needed:
2 - 2x4 at least 30” long
1 - 1/2” socket
1 - 1/2” open end wrench
1 - hammer
1 - pliers
Parts bag contains:
2 - Handle Grips
2 - Handle End Caps
4 - Screws, .313-18X1.75
1 - Cotter Pin
2 - Washers, 5/8" X 1.32 X .09
1 - Flat Steel Washer
2 - Axle Spacer
2 - Cap Screw 5/16-18 X 3/4
6 - Flange Nuts
2 - Wheel Brackets
1 - 5/8” Axle Cap