Filter
Top Products
7- ENG
A08989
7. Attach cleaning solution hose
to barb fitting on control valve
located at the rear of unit.
(see Fig. 7)
8. Add engine oil (supplied)
to engine. Refer to Engine
Owners Manual supplied by
engine manufacturer for correct
procedure.
NOTE: There will be a slight amount
of oil in the engine from factory
testing.
NOTE: The pump on this unit is
maintenance-free and requires no oil. If
there is a problem with the pump call:
1-866-4SIMONIZ (1 866 474 6664).
5. To Assemble Accessories
Panel
a. Remove top screws on
handle assembly. (see Fig. 5)
Loosen
Remove
Screws
b. Loosen bottom screws on
handle assembly.
c. Place grooves in accessories
panel assembly onto
loosened bottom screws and
slide panel assembly into
place.
d. Place top screws (removed
earlier) into top holes. Fasten
screws to secure accessories
panel assembly to handles.
Do not overtighten.
6.
Re-install cleaning solution tanks.
Tilt cleaning solution tanks toward
engine, slide onto handles, and
snap into place. (see 6a and 6b)
barb fitting
Fig. 5
Fig. 6a
Fig. 6b
Fig. 7