11- ENG
A08989
HOW TO USE DUAL
DETERGENT INJECTION
SYSTEM
NOTE: Use only soaps and cleaning
solutions designed for pressure
washer use. Do not use bleach.
To apply cleaning solutions:
1. Make sure cleaning solution
tanks are assembled and all
hoses are connected.
2. Turn detergent selection dial
arrow to the down (off) position
as shown in Fig. 12.
3. Fill cleaning solution tanks with
desired cleaning solution. Each
tank holds approximately 1 1/4
gallons. NOTE: The cleaning
solution/water ratio is 7:1, for
every 7 gallons of water pumped,
1 gallon of cleaning solution will
be used.
Never fill cleaning
solution tanks
with gasoline or other flammable
solvent.
4. Turn detergent selection
dial toward tank with desired
cleaning solution. (see Fig. 13)
Detergent selection dial
Tank to
be used
5. Set multi-adjustable nozzle to
low pressure setting. See How
To Use Spray Wand paragraph in
this section.
6. After use of cleaning solution
the detergent injection system
MUST be rinsed, follow the
instructions in the Shutting
Down paragraph after each
use.
NOTE: Cleaning solutions will not
siphon when spray wand is in the high
pressure setting.
DUAL DETERGENT INJECTION
SYSTEM SOLUTION TIPS
1. Each tank may be filled with
different cleaning solutions
depending on the task to be
performed. Example: deck and
driveway. Fill one tank with deck
cleaning solution and the other
with driveway cleaning solution.
Clean the deck with the deck
cleaning solution. When finished
with the deck, simply turn the
detergent selection dial toward
the driveway cleaning solution
and clean the driveway.
2. a. If only one cleaning solution
is being used, both tanks
may be filled with the same
solution to double the
capacity.
b. If only one cleaning solution
is being used, the second
tank may be filled with
clean water to conveniently
rinse the detergent injection
system after use.
Fig. 12
Fig. 13