Filter
Top Products
www.desatech.com
6 122393-01A
4. Install electronic ignitor through control
panel as shown in Figure 4, page 5. Screw
retainer ring and ignitor cap on from outside
panel. Attach ignitor ground wire to ignitor.
5. Remove wire tie and packing material
from regulator located underneath burner
support plate.
6. Position burner support plate on top of
panels while carefully inserting control
valve through hole in control panel.
7. Attach control valve bracket to table
control panel with 2 screws (C). Attach
control knob to control valve from outside
of heater. See Figure 5.
8. Attach burner support plate to panels with
4 screws (C) (see Figure 5).
9.
Attach emitter screens to emitter brackets
with 4 screws (C) as shown in the Figure 5.
10. Attach emitter cap to emitter brackets with
2 screws (C) as shown in Figure 5.
ASSEMBLY
Continued
Burner
Support
Plate
Figure 7 - Attaching Grate Assembly to
Heater
Screw (C)
through
Deco
Grate
Pillar
Figure 6 - Deco Grate and Grate Pillar
Assembly
11. Attach emitter assembly to burner support
plate with 2 screws (C) (see Figure 5).
12. Model TD109A only: Place 3 screens
around grate pillars. For all models, place 3
table decorative grate pieces around grate
pillars. Attach to grate pillars with 4 screws
(C) per grate as shown in Figure 6.
Burner
Support
Plate
Hole for
Control
Valve
Control
Knob
Figure 5 - Assembling Emitter and
Attaching Burner Support Plate
Emitter Cap
Emitter
Screen
Emitter
Bracket
Control Valve
Underneath
Burner
Support Plate
Ring
Retainer
Screen
(Model
TD109A
only)
Table Decorative
Grate (Models
TD101A, TD103A
and TD111A
shown)
Deco
Grate
Pillar
(Holes
closest to
edge should
be on the
bottom)
All
Screws
(C)
All Screws (C)