Filter
Top Products
ADJUSTING AND OPERATING
MAIN DRIVE BELTS
7 -Transmission drive idler
8 -Transmission brake rod assembly
9 -Drive chain
10 -Crankshaft -mower drive pulley
11 -Transmission drive pulley
1 -Main drive belt
2 -Safety starting switch
3 -Mower clutch control
4 -Oil drain hole
5 -Mower drive belt idler
6 -Clutch-brake pedal return spring
Underside of riding mower with mower removed to show mower drive belt,
pulleys, rear axle drive chain, etc.
NOTE II A II -Period ically check the transm ission
brake rod spring. If the spring length exceeds
1-1/2-inches with the brake pedal in the locked
position readjust the locknut and jam nut on the
end of the rod to obtain the proper adjustment of
1-1/2-inches. Tighten the nuts relative to each
other until firmly locked together to insure that
they will not loosen up.
-13-