Cub Cadet HP LS 27 CC Log Splitter User Manual


 
4 se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e s
If your machine is equipped with an internal combustion 13.
engine and is intended for use near any unimproved forest,
brush, or grass covered land, the engine exhaust should be
equipped with a spark arrestor. Make sure you comply with
applicable local, state, and federal codes. Take appropriate
firefighting equipment with you.
This machine should be used for splitting wood only, do 14.
not use it for any other purpose.
Follow the instructions in the manual(s) provided with any 15.
attachment(s) for this machine.
Preparation
Always wear safety shoes or heavy boots. 1.
Always wear safety glasses or safety goggles when 2.
operating this machine.
Never wear jewelry or loose clothing that might become 3.
entangled in moving or rotating parts of the machine.
Make sure machine is on a flat, dry, solid ground before 4.
operating.
Always block wheels to prevent unintended movement, 5.
and lock beam in either the horizontal or vertical position.
Always operate this machine from the operator zone(s) 6.
specified in the manual. See Fig. 2-1.
Logs should be cut with square ends prior to splitting.7.
Use log splitter in daylight or under good artificial light.8.
Safe Handling of Gasoline
To avoid personal injury or property damage use extreme care
in handling gasoline. Gasoline is extremely flammable and the
vapors are explosive. Serious personal injury can occur when
gasoline is spilled on yourself or your clothes which can ignite.
Wash your skin and change clothes immediately.
Use only an approved gasoline container.a.
Extinguish all cigarettes, cigars, pipes, and other b.
sources of ignition.
Never fuel machine indoors.c.
Never remove gas cap or add fuel while the engine is d.
hot or running.
Allow engine to cool at least two minutes before e.
refueling.
Never overfill the fuel tank. Fill tank to no more than f.
1/2 inch below bottom of filler neck to provide space
for fuel expansion.
Replace gasoline cap and tighten securely.g.
If gasoline is spilled, wipe it off the engine and h.
equipment and move machine to another area. Wait
five (5) minutes before starting the engine.
Never store the machine or fuel container inside i.
where there is an open flame, spark or pilot light
as on a water heater, space heater, furnace, clothes
dryer or other gas appliances.
Allow machine to cool at least five (5) minutes j.
before storing.
Operation
Before starting this machine, review the “Safe Operation 1.
Practices”. Failure to follow these rules may result in serious
injury to the operator or bystanders.
Never leave this machine unattended with the engine 2.
running.
Do not operate machine while under the influence of 3.
alcohol, drugs, or medication.
Never allow anyone to operate this machine without 4.
proper instruction.
Always operate this machine with all safety equipment in 5.
place and working. Make sure all controls are operating
properly for safe operation.
Operator Zone6.
Horizontal Operating Position: Stand on the control a.
lever side of the log splitter and stabilize log as
shown, if needed. See Fig. 2-1.
Vertical Operating Position: Stand in front of the log b.
splitter and stabilize log as shown, if needed. See
Fig. 2-1.
WARNING! When stabilizing log with left hand,
remove your hand when the wedge just contacts
the log or serious injury may occur.
When loading a log, always place your hands on the side 7.
of the log, not on the ends, and never use your foot to help
stabilize a log. Failure to do so, may result in crushed or
amputated fingers, toes, hand, or foot.
Use only your right hand to operate the controls.8.
Never attempt to split more than one log at a time.9.
For logs which are not cut square, the least square end of 10.
the log should be placed toward the beam and wedge, and
the square end placed toward the end plate.
Horizontal
Vertical
Figure 2-1