Cub Cadet GTX 2100 Lawn Mower User Manual


  Open as PDF
of 32
 
Section 6 — Maintenance & adjuStMentS
Hydrostatic Transmission Oil
Checking the Hydrostatic Transmission Oil
The dipstick to check the hydrostatic transmission oil level is
located on the back of the mower on the upper section of the
frame. Refer to the Controls & Features section of this manual.
 Remove the dipstick and check the level. See Figure 6-2.
F
A
Full
Add
OK
Figure 6-2
2. 
is not necessary to add any transmission oil. If the level is at




NOTE: The approved fluid is Cub Cadet Drive System Fluid
Plus
 Reinstall the transmission oil fill plug/dipstick securely into
the oil fill port.
4. Start the engine and allow it to run for a few minutes. Shut
the engine off, then check for leaks and re-check the oil
level in the transmission case.
Changing the Hydrostatic Transmission Oil
CAUTION: Never overfill the transmission case.
Damage or leakage may result if the oil level in the


 Place the tractor on a level surface and engage the brake pedal
lock. Stop the tractor engine and remove the ignition key.
2. Clean the area around the transmission drain plug to
prevent debris from entering the transmission case.
4. While holding the free end of the oil drain hose over the oil
collection container, unscrew the square head hose plug

oil into the collection container.
Oil Drain Hose
Square Head Plug
Figure 6-1
5. After draining the oil, wipe any residual oil from the oil
drain hose. Thread the square head plug into the drain
hose fitting and fully tighten the plug.
6. Replace the oil filter, and refill the engine with new oil as

7. Re-insert hose through the retaining loop-clamp.
To refill the oil, re-install the square head plug at the end of

instructions, oil type and amount.
NOTE: Maintenance, repair, or replacement of the emission control

be performed by any engine repair establishment or individual.
Warranty repairs must be performed by a Cub Cadet Dealer.
19
 previous next