Cub Cadet 945 SWE Snow Blower User Manual


 
Place chute assembly onto chute base as shown in Figure 3-5.
Make sure that the chute notches engage with the spiral end
of chute directional control, and the two flange keepers are
beneath the flange on the chute base.
Secure flange keeper removed earlier with lock nuts and screws.
Tighten down nuts securing the other two flange keepers. See
Figure 3-6.
Check that the chute cables are properly routed through the
cable guide attached to the lower handle assembly. See Figure
3-5.
NOTE: If the connector is not properly assembled, the shift rod
will pivot and you will not be able to change speeds or direction.
If the full range of speeds (forward and reverse) can not be
achieved, refer to the “Maintenance and Adjustments” section.
Chute Directional Control
Remove the internal cotter pin from the upper chute crank. Slide
the upper chute crank into the sleeve on the lower chute crank.
Align the hole in the upper chute crank with the hole in the
sleeve (If necessary, use a pair of pliers to assist in aligning holes).
Insert the internal cotter pin through the holes to secure the
chute crank. See Figure 3-4.
Chute Assembly
Remove lock nuts and screws securing one of the flange keepers
to the chute assembly. Loosen the fasteners of the other two
flange keepers. See Figure 3-5.
Figure 3-4
Figure 3-5
Figure 3-6
a
b
8 se c t i O n 3— as s e M b l y & se t-up