Filter
Top Products
Assembly & Set-Up
3
9
Tractor Preparation
Remove the upper crating material from the shipping pallet, and
cut any bands or tie straps securing the tractor to the pallet.
Use the lift handle to raise the deck to its highest position.
Engage the transmission bypass rods on each side of the
tractor; then carefully roll the tractor off the shipping pallet.
The transmission bypass rods (one for each the RH and LH
transmission) are located beneath the frame platform, just inside
Keyhole Slot
Transmission
Bypass Rods
Figure 1-1
Remove the deck wash system nozzle adapter and oil drain tube
from the manual bag and store for future use. Cut the wire tie
holding the chute deflector up and discard any packing material.
Install Operator’s Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan
attached.
Cut any straps securing the seat assembly and the drive
control levers to the tractor. Remove any packing material.
NOTE:
seat and the seat switch in the bottom of the seat.
Contents of Crate
2. Remove the two shoulder bolts, nuts and spacers securing
Bolt
Nut
Figure 1-2
Rotate the seat into position and secure the seat into place
with the previously removed shoulder bolts, nuts and
Spacer
Wire Harness
Bolt
Nut
Figure 1-3