Filter
Top Products
Assembly & Set-Up
3
7
Contents of Crate
• One Snow Thrower • Two Replacement Auger Shear Pins • One Chute Assembly
• One Snow Thrower Operator’s
Manual
• One Product Registration Card • One Chute Control Rod
• One Engine Manual
Assembly
Handle
1. Place the shift lever in the Forward-6 position
2. Remove the lower plastic wing nut and carriage bolt from
each side of the upper handle; then raise the upper handle
assembly until it snaps over the lower handle. See Figure
3-1.
Figure 3-1
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
3. Looking beneath the handle panel, check that all of the
cables (steering, auger, shift, and drive) are properly routed
and not pinched or kinked.
4. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
1. Remove cotter pin, wing nut and hex screw from chute
control head. Remove clevis pin and bow-tie cotter pin
from chute support bracket. See Figure 3-3.
Figure 3-2
Chute Control Head
Chute
Chute Support
Bracket
Chute Base
Figure 3-3