Cub Cadet 5264D Lawn Mower User Manual


 
43
Place a suitable container beneath the drain
plug and remove the cap from the overflow
reservoir.
Turn the drain plug counterclockwise to re-
move. Allow as much of the old coolant as pos-
sible to drain from the system.
Coolant is a toxic substance. Dispose of in
an environmentally safe manner. Contact
your area EPA office for proper disposal
methods and recycling center locations.
Reinstall the drain plug and turn clockwise until
fully tightened.
Turn the radiator cap counterclockwise to the
first stop, then push downward on the cap and
turn counterclockwise to remove. Refer to
Figure 49.
In stages, SLOWLY pour the coolant solution
into the filler neck, allowing as much air as
possible to escape through the neck. Fill to the
overflow flange of the filler neck.
Wait a few minutes to allow air to escape
through the filler neck and refill as needed, then
reinstall the radiator cap.
Fill the overflow reservoir to the "FULL" mark.
Start the engine and allow it to run for a short
period. Stop the engine.
Recheck the coolant level in the overflow
reservoir and refill as needed. Reinstall the
reservoir cap.
CHANGING THE AIR CLEANER
Check the air cleaner daily or before starting the
engine. Check for loose or damaged components
and check the condition of the filter element.
Remove any buildup of dirt and debris in the air
cleaner housing.
Replace the paper air cleaner element after every
300 hours of operation. More often if operating the
tractor under extremely dusty conditions.
Check and replace the air cleaner element as follows:
Unlock the clamps to remove the air cleaner
housing cover. See Figure 55.
Figure 55
Pull the air cleaner element from the housing.
See Figure 56.
Figure 56
Lightly blow or brush loose debris from the air
cleaner element. Clean any debris from the
housing.
Inspect the paper pleats of the cleaner element
for damage and dirt. Inspect the sealing surface
on the inner end of the element for deterioration
or damage. Replace a damaged or dirty air
cleaner element.
Push the new air cleaner element fully into the
housing.
Position the cover on the housing. Hook the
two clamps onto the rim of the housing and lock
the clamps. Refer to Figure 55.
IMPORTANT: A clean and properly installed
air cleaner element significantly contributes to
prolonging engine life.
COVER
COVER
CLAMP
Pull Outward
to Unlock
AIR
CLEANER
HOUSING
AIR
CLEANER
ELEMENT