Filter
Top Products
30
• Turn the bulb/socket assembly approximately a
quarter turn counterclockwise to align its tabs
with the notches of the reflector, then remove
from the reflector. See Figure 36.
Figure 36
• Replace with a new bulb/socket assembly (Cub
Cadet No. 725-04084).
• Align the tabs of the new bulb/socket assembly
with the notches of the reflector and insert the
bulb.
• Turn the bulb/socket assembly clockwise to
lock in place. Push the wire harness plug fully
into the bulb socket.
HAZARD BULB REPLACEMENT
Flashing hazard lights are installed on each side of
the ROPS. Referring to Figure 37, replace the bulbs
as follows:
Figure 37
• Insert a thin bladed screwdriver, or similar tool,
between an amber lense and the hazard light
body, then twist to separate the lense from the
body. Refer to Figure 37.
• Push the bulb inward and turn counterclockwise,
then pull the bulb outward to remove from the
light socket. Refer to Figure 37.
• Align the new bulb with the socket slot, push
the bulb into the socket, and turn clockwise to
lock it in the socket.
• Position the lense on the hazard light body and
push the lense onto the body until it snaps
firmly into place on the body.
SERVICING ELECTRICAL SYSTEM
Fuses are installed to protect the tractor’s electrical
system from damage caused by excessive amper-
age. Always use the same capacity fuse for
replacement. If the electrical system does not func-
tion, check for blown fuses. See Figure 38
If you have a recurring problem with blown fuses,
have the tractor’s electrical system checked by your
Cub Cadet dealer.
Figure 38
Main Fuse
The main fuse in the tractor wire harness protects
the tractor’s entire electrical system. A blown main
fuse will prevent battery current from passing
though the harness.
To replace the main fuse:
• Raise the tractor hood.
• Locate the main fuse on the lower/right pedes-
tal beneath the dash panel. See Figure 39.
Figure 39
• Pull the fuse from the fuse holder and replace
with the same capacity fuse (30 Amp). NEVER
use a higher amperage fuse.
• Lower the tractor hood.
BULB/SOCKET
ASSEMBLY
WIRE
HARNESS
PLUG
REFLECTOR
AMBER
BULB
SOCKET
Push in
and Turn
LENSE
BODY
GOOD
BAD
MAIN FUSE
DASH
FUSE HOLDER
PANEL
WIRE
HARNESS